
Department of Energy, there may be over 100 GW of geothermal electric capacity in the continental U.S., which would account for nearly 10% of current U.S. Injected fluid is heated by the rock and returned to the surface to generate electricity. EGS creates a subsurface fracture system to increase the permeability of rock and allow for the injection of a heat transfer fluid (typically water).

Binary cycle power plants feature geothermal water and a working fluid that are confined to separate circulating systems, or “closed loops.” A heat exchanger transfers heat from the water to the working fluid, causing it to “flash” to steam, which then powers the turbine/generator to produce electricity.

Flash steam plants are the most common type of geothermal power plants. This pressure change causes the water to rapidly “flash” into steam, which is then used to spin a turbine/generator to produce electricity. Flash steam power plants pump hot water under high pressure into a surface tank at much lower pressure.Dry steam power plants use steam from a geothermal reservoir and route it directly through turbines, which drive generators to produce electricity.The water is often pumped as steam to the earth’s surface to spin turbines that generate electricity. Hydrothermal energy, typically supplied by underground water reservoirs, is a main source of thermal energy used in electricity generation.generated the most geothermal electricity in the world: more than 18,700 GWh. Geothermal energy currently accounts for 0.4% of net electricity generation in the United States.The U.S., Indonesia, Philippines, Turkey, New Zealand, and Mexico had 72% of global installed geothermal power capacity in 2020.7,8 In 2016, California, Nevada, Utah, and Hawaii were the states with the most installed geothermal energy capacity. Electricity generated from geothermal plants is projected to increase from 17 billion kWh in 2020 to 49.8 billion kWh in 2050.In 2016, there were 3,812 MW of geothermal electricity plants in operation in the U.S.-the most of any country-and development has been growing at a rate of 2% per year.has tapped less than 0.7% of geothermal electricity resources the majority can become available with Enhanced Geothermal System technology.

Ground source heat pumps for heating and cooling use 75% less energy than traditional heating and cooling systems.Geothermal energy has two primary applications: heating/cooling and electricity generation.Nearly all heating and cooling applications utilize low enthalpy heat. 1 It exists in both high enthalpy (volcanoes, geysers) and low enthalpy forms (heat stored in rocks in the Earth’s crust). Geothermal energy is derived from the natural heat of the earth.
